Installation Guide

Fitting Your Watch Strap

Install your watch strap correctly for a proper and comfortable fit with maximized aesthetics. Here are the step-by-step instructions with demonstrations on video.

Before installing:
Prepare a proper workspace. Use a clean open surface like a table or countertop.
Put a towel on the surface to protect the watch and keep things together.
Get your spring bar tools ready.

Work from the underside of the watch.
Installing Two-Piece Watch Strap

Two-Piece Watch Strap

1. Secure the spring bars to the watch lug. Make sure both ends are snapped securely into their respective holes.

2. The shorter band with the buckle goes on the top of the watch (12 o’clock). Insert one end of the spring bar into the hole on the watch lug.

3. Use the spring bar tool to compress the other end of the spring bar, and slide it into place. Make sure both ends are snapped securely.

4. Repeat the process on the longer band which attaches to the bottom of the lug (6 o’clock).
Installing Single Pass Watch Strap

Single Pass Watch Strap

1. Insert spring bar into the slot of the lug end of the strap

2. The buckle end of the band should be on the top of the watch (12 o’clock).

3. Loop the end of the strap without the buckle over the top spring bar. Continue to loop the strap under the lug, and finally over the bottom spring bar.

4. Adjust accordingly, and you’re done!

A Clean Look

Installing a single pass watch strap is easy. With the right adjustments, you can achieve a sleek look similar to when you put on a 2 piece strap. This trick will help your watch sit flat on your wrist without keepers protruding at the sides.

1. Position the keeper of the strap about 3cm above the watch lug (12 o’clock position).

2. Upon securing the strap, the buckle will be closer to the lug below (6 o’clock position) instead of being at the center of your inner wrist.

3. The bulky parts of the buckle and keepers will be hidden underneath. Only one layer of strap will be visible from the top.
Two Ways to Loop

The length of a single pass watch strap can be adjusted according to your wrist size. There are two ways to fix the strap for adjustments.

The Firm Loop

Requires a little more effort and practice, but the strap’s hold will be firmer and last longer. Refer to the video to set it up correctly.

The Quick Adjustment Loop

Easier and faster to adjust, but the hold may loosen after some time.

Refer to the video for the steps.

Step-by-step Guide:Installing Single Pass Watch Straps

This is how the firm and quick adjustment loops will look.

Determining which loop to use depends on your wrist size, watch weight, lug size, and lug-and-strap combination. It is to be noted that the Herringbone Twill, X-Hatch and Reversible Silk Watch Straps do not need a firm loop to stay in position.

If you are facing any issues with installing a strap, do contact us for assistance.